Add comments to initialisation code. Remove debug prints. Remove some (probably) unnecessary comments.

git-svn-id: svn+ssh://oldsvn/home/mlalondesvn/svn/cral@66 3ee9b42a-b53c-0410-a25e-f0b6218d5d5b

branches/follower/wiz810mj/src/demo/WizDemo1/WizDemo1.pde

@@ -95,25 +95,31 @@ void initModule() {
      
    */
 
-  // I thought this wasn't needed but seems like it is.  
+  /*
-  Serial.println("Triggering reset...");
+     Initialise the W5100 chip
+     
+     (Originally I thought it was possible for the chip
+      to function without a hardware reset but it
+      seems not to be the case.)
+   */   
   pinMode(PIN_RESET, OUTPUT);
   
-  digitalWrite(PIN_RESET, HIGH); // no reset
+  // We rely on the time between function calls to
-  //delay(10); // Pretty arbitrary length -- do we need it?
+  // be long enough for the chip to recognise the
+  // reset.
+  digitalWrite(PIN_RESET, HIGH);
   digitalWrite(PIN_RESET, LOW); // reset
-  //delay(10);
+  digitalWrite(PIN_RESET, HIGH);
-  digitalWrite(PIN_RESET, HIGH); // no reset
-  //delay(10);
-  Serial.println("Reset triggered...");
   
-
+  // Chip initialisation by driver
-  // driver chip init (Might be redundant with the above reset.)
+  // Might be redundant following the above reset,
-  Serial.println("Call iinchip_init...");
+  // as this performs a software reset.
   iinchip_init();
   
-  // driver sysinit
+  // Initialise driver
-  Serial.println("Call sysinit...");
+  // (This is required to configure some variables used
+  // internally by the driver--even if the default chip
+  // configuration is used.)
   sysinit(0x55, 0x55);
   
 }